How to take measurements for a men's dress uniform

How to take measurements for a men's dress uniform

Taking your measurements at home is not difficult: just be careful. It is better to measure several times than to make a mistake. Below: what you need, how to stand, where the tape goes and what to write down.

What you need

  • A measuring tape.
  • A pen and paper.
  • A helper: measuring yourself is awkward and less accurate.

Before you start

  • Measure over a thin T-shirt (women: in a bra).
  • The person measuring stands facing you.
  • Stand relaxed: shoulders level, arms down at your sides, feet together.
  • The tape lies exactly along the body: not tight, not loose, with no slack or allowance. At the front and at the back it runs parallel to the floor.
  • Count from the «0» end of the tape: place the zero carefully at the right point.

Measurement diagram

Each measurement on the diagram has its own code. The key is below, in the same order.

Diagram: how to take measurements for a men's dress uniform

Measurements in order

CodeMeasurementHow to take it
HHeightbarefoot, standing straight.
NNeckat the back around the base of the neck, in front just under the Adam's apple. Do not pull the tape tight.
SShoulder lengthfrom the base of the neck to the shoulder tip.
SLSleeve lengthfrom the shoulder tip to the wrist.
CChestacross the shoulder blades and the fullest part of the chest.
WWaistat the navel. This is the starting point.
BWaistbandwhere you wear your trousers, along the underwear line. It is most accurate to measure over trousers that fit you well.
Hp-1Hips 1 (upper)check measurement, about 4–5 cm above the main one.
HpHips: MAINthe largest hip girth, feet together. This is the number we record.
Hp-2Hips 2 (lower)check measurement, about 4–5 cm below the main one.
TLTrouser lengththe tape follows the hip, and where the hip starts to narrow it drops straight down the side to the floor.
HDHeadabove the eyebrows, along the line where the cap sits. See the life hack below for an accurate way to do it.

Hips: three tapes, one number

For men the most important thing is to find the largest hip girth. That is why the diagram shows three tapes: a green one in the middle and two yellow ones (a little higher and a little lower). Measure all three and record the largest value: this is the main measurement «Hp». The two check measurements help you not to miss the widest point.

Head size for a cap: a life hack

Head girth is easy to measure inaccurately. Here is a simple method we recommend to our customers:

  1. Make a loop from the measuring tape and clip it with a paperclip at your estimated size, for example 57.
  2. Put the ring on your head the way you would wear the cap: above the eyebrows, along the line where it sits.
  3. Too tight or too loose? Make the ring larger or smaller and try again. When it sits right, that is your size.

Life hack: how to measure your head size for a cap

Check yourself

Take the measurements twice and write the results side by side. If the numbers match, send them. If not, check again: place the zero of the tape on the right point again and make sure the tape runs parallel to the floor.

What next

Send us your measurements on Viber or WhatsApp: +38 067 751-24-69. A manager will go through them with you and tell you if anything looks doubtful.

Message on ViberMessage on WhatsAppAll contacts

Back call